Lenovo Flex System Fabric CN4093, Application Manual

Page: 340 / 634

340
CN4093 Application Guide for N/OS 8.4
Repeat as necessary for each member device.
c.
Exit from zone configuration:
3.
For each desired zoneset:
a.
Name (or remove) the zoneset.
b.
Add (or remove) one or more member zones to the zoneset:
Repeat as necessary for each member zone.
c.
Exit from zoneset configuration:
Activating Zoneset
Fibre Channel is intended to operate with minimal disruption. To prevent the
various synchronization events that would result if each stage of a live zoning
configuration was applied, the cumulative configuration changes for zones and
zoneset are held in reserve until explicitly activated by the administrator.
When activated, the new zoneset will be synchronized throughout the Fibre
Channel fabric for each modified zone. Fibre Channel traffic will be temporarily
disrupted in modified zones as changes to the fabric are recognized by the
connected devices. Until activation, the previously established zoneset will remain
in effect.
The basic zoneset commands are as follows:
 Activate or deactivate a zoneset:
 View the settings for the active zoneset:
 View the settings for the pending configuration changes:
CN 4093(config-zone)# exit
CN 4093(config)# [no] zoneset name
<zoneset name>
CN 4093(config-zoneset)# [no] member
<zone name>
CN 4093(config-zone)# exit
CN 4093(config)# [no] zoneset activate name
<zoneset name>
CN 4093# show zoneset active
CN 4093# show zoneset