Lenovo 7D31, Maintenance Manual

Page: 163 / 274

Step 2. Install the memory module into the slot.
Figure 69. Installing a memory module
Gently open the retaining clip on each end of the memory module slot.
Align the memory module with the slot, and gently place the memory module on the slot.
Firmly press both ends of the memory module straight down until the retaining clips snap
into the locked position.
Note:
If there is a gap between the memory module and the retaining clips, the memory module
has not been correctly inserted. In this case, open the retaining clips, remove the memory module,
and then reinsert it.
After this task is completed
Proceed to complete the parts replacement (see “Complete the parts replacement” on page 218).
OCP Ethernet adapter replacement
Follow instructions in this section to install or remove the OCP Ethernet adapter .
Remove the OCP Ethernet adapter
Follow instructions in this section to remove the OCP Ethernet adapter.
About this task
Chapter 4
.
Hardware replacement procedures
155