LELY COSMIX S, Manual, Page: 22 / 102

2-4 Safety
D-I011.1106EN
innovators in agriculture
2.4 Safety Decals
2.4.1 Safety Decal Messages
General safety messages appear in this safety messages section. Specific
safety messages are in applicable parts of this manual when potential
hazards may occur if the instructions or procedures are not followed.
2.4.1.1 Rotating Parts - Entanglement Hazard
Figure 1. Rotating Parts - Entanglement Hazard Symbol
WARNING
Danger of being entangled by rotating parts.
Keep hands, loose clothing, and long hair away from moving parts
during operation of the COSMIX S.
2.4.2 Installation of Safety Decals
1. Make sure the installation surface is clean and dry.
2. Make sure the temperature of the mounting surface is not less than
5 °C (41 °F).
3. Identify the correct position for the decal before you remove the
backing paper.
4. Remove a small part of the backing paper.
5. Put the decal in the correct position on the mounting surface and
carefully press the small part of exposed adhesive surface of the
decal onto the mounting surface.
6. Slowly remove the backing paper and attach the rest of the decal to
the mounting surface.
7. Puncture small air pockets in the decal with a pin and use the
backing paper to smooth the decal.
2.4.3 Maintenance of Safety Decals
Safety decals on the COSMIX S Concentrate Feeder display important
and useful information that will help you safely operate and maintain
the COSMIX S.
Obey the instructions below to make sure all the decals stay in the
correct position and condition.
•
Keep the safety decals clean and legible at all times. Clean the safety
decals with soap and water. Do not use mineral spirits, abrasive
cleaners or other similar agents that may damage the safety decals
•
Replace safety decals that are missing or are illegible
•
Safety decals can be purchased from your local Lely service provider.