18
Instruction manual V3.1 02/2001
7. Setting up the instrument
7
6
Fig. 18
7.2 Installing the arm rests
Insert the pins on the underside of the arm rests
(6)
into the corresponding holes
(7)
of the microtome
base plate as shown.
7.3 Switching on the instrument
Switch on the mains switch at the rear of the in-
strument.
Switching on the mains switch is followed by a beep.
The instrument initializes.
Next the software version is displayed in the four-digit
display for approximately 2 seconds.
Depending on the preselected setting, one of the two
three-digit displays either reads the currently selected
sectioning
(SECT./µm)
or trimming thickness
(TRIM/µm)
- (Shown here is the section thickness).
After turning on the instrument, all displays and the
LEDs of all activated functions are illuminated.
Summary of Contents for RM2145
Page 2: ......
