45
3.5.4 FUNCTION 4: VIEW & EXECUTE PROFILES
To execute a profile, press Function Select and then press “4”. This will bring you back into
the Main Screen as shown below. You will need to enter the profile number that you want to
execute. A full explanation of profiles is given in Section 4.
Units: knots Feet/min
Feet
Actual: M 101.2
3500
1005 M
Target:
20.0
3000
0
ENTER PROFILE NUMBER :
.
Profiles may be executed from both 2-output and 3-output formats. During the execution of a
profile, it is possible to toggle between the two formats using the PREV SCREEN key.
Assuming you enter a profile number of “2.1”, followed by the ENTER key, the first point of
profile # 2 will be displayed on the screen. Also, the name of the profile is shown here. This is
shown in the screen below. The name of profile 2 is CJ1-RVSM. In this profile note that both
Modes changed to “C”, and all three target values changed. These parameters were
programmed as the first point of profile # 2. You will also notice that the number “2.1” is
flashing. This indicates that the current profile point is ready for execution and awaiting the
“GO” key to be pressed. When the “GO” key is pressed, the 6600 will execute the profile
point, i.e. it will change to Control mode and move towards the desired targets.
Units: knots Feet/min
Feet
Actual: C 101.2
3500
1005 C
Target:
100.0
5000
1000
ENTER PROFILE NUMBER : 2.1 CJ1-RVSM
Once the targets have been achieved, you can move to the next profile point by pressing
ENTER. Then, the parameter values in point 2 of profile # 2 will be displayed, the profile
number will change to “2.2” and will again flash, awaiting the “GO” key.
If you want only to view the profile without executing it, then DO NOT press the “GO” key.
Simply press the “ENTER” key to go to the next point in the profile. Each time you press the
“ENTER” key, the next profile point will be displayed. When you press the “ENTER” key
after the last point in the profile, the Main screen will revert back to its original setting prior to
invoking Function 4.
At any time, to exit out of the profile viewing or execution function, press CANCEL and the
screen will revert back to the last executed point and line 4 will be cleared.
Summary of Contents for 6600
Page 10: ...3 Figure 2 1 A...
Page 11: ...4 Figure 2 1 b...
Page 15: ...8 Figure 2 2...
Page 16: ...9 Figure 2 3...