Laversab 6600, User Manual, Page: 28 / 79

21
Parameter 10. Ps1 “Target” value: This is the value that you command the 6600 to
achieve on the Ps1 output. This parameter is accessible in both 2-output and 3-output
formats. In the sample screen below, the 6600 has been commanded to achieve a pressure of 0
Feet on the Ps1 output. The Ps1 “Target” value is meaningful only when the Ps1 output is in
the “Control” mode. This is explained later in this section. How to change the Ps1 “Target”
value is explained in section 3.2.2.
2-output format
Units: knots Feet/min Feet
Actual: M 101.2 3500 1005 M
Target: 20.0 3000 0
Parameter 11. Ps2 “Target” value:
This is the value that you command the 6600 to
achieve on the Ps2 output. This parameter is accessible only in the 3-output format. In the
sample screen below, the 6600 has been commanded to achieve a pressure of 10 Feet on the
Ps2 output. The Ps2 “Target” value is meaningful only when the Ps2 output is in the
“Control” mode. This is explained later in this section. How to change the Ps2 “Target” value
is explained in section 3.2.2.
3
-output format
Units: knots Feet Feet
Actual: M 101.2 1006 M 1005 M
Target: 20.0 10 0
Parameter 12. Rate “Target” value:
This is the value that you command the 6600 to
achieve as the rate of change of pressure on the Ps1 output. This parameter is accessible only
in the 2-output format.
Caution: This target value is also used for controlling the rate of change of pressure on the
Ps2 output and under certain conditions, also the rate of change of pressure on the Pt
output. For details please refer to ”Effects of Rate Target Value” in section 3.2.2.
In the sample screen below, the 6600 has been commanded to achieve a rate of change of 3000
Feet/min. on the Ps1 and Ps2 outputs. The Ps1 Rate “Target” value is meaningful only when
the Ps1 (and/or Ps2, Pt) output is in the “Control” mode. This is explained later in this
section. How to change the Ps1 Rate “Target” value is explained in section 3.2.2.