Laserscale SET-HD100, Instruction Manual

Page: 50 / 74

SET-HD100
6
(E)
3. Installation and Connections
Notes
• Be sure to always install and use the product in an environment within the specifi ed temperature range.
• Cooling fans are provided on both sides of the interpolator unit. Do not block the air outlets in order
to prevent the interior of the interpolator unit from overheating. Also, separate both sides of the
interpolator unit by at least 50 mm from other objects.
• Th
e functions and performance of this product are not guaranteed when used with other than the head
unit, scale unit and interpolator unit combination provided when shipped from the factory, even if
the other devices are the same products. Always use the provided combination. Th
e combination can
be checked by the serial number of each unit. (See section 9 “Dimensions” for the serial number label
locations.)
3-1. Installation
3-1-1. Items to be Prepared
• Scale unit (supplied)
• Head unit (supplied)
• Scale unit mounting screws (See section 8 “Specifi cations” and section 9 “Dimensions.”)
• Head unit mounting screws (See section 8 “Specifi cations” and section 9 “Dimensions.”)
• Torque
wrench
• Dial test indicator, microscope (approximately ×100 to ×1000), etc.
3-1-2. Installation Work Flow
Check the parallelism between the scale unit mounting surface and rotational surface.

Check the clearance between the scale unit mounting surface and the head unit mounting surface.

Temporarily mount the scale unit.

Adjust the eccentricity of the scale unit.

Mount the scale unit.

Temporarily mount the head unit.

Axes alignment of the head unit and scale unit.

Mount the head unit.