Laserscale SET-HD100, Instruction Manual

Page: 49 / 74

SET-HD100
(E)
5
2-3-2. Rear Panel
2 Fuse
3 Power supply connector
4 Ground terminal
1 POWER switch
a POWER switch
Th is turns the interpolator unit power on and off .
Notes
• Finish all the connections before turning on the power. (See section 3-2 “Connections.”)
• Be sure to always turn off the power before connecting or disconnecting the connection cable. If the
cable is connected or disconnected while the power is on, the sensor light source may be damaged.
b Fuse
Th is fuse is used to prevent overcurrent.
Notes
• Be sure to always use the specifi ed fuse
*
. (
*
: Rated voltage 250 V, rated current 15 A)
• Be sure to always turn off the power before replacing the fuse.
c Power supply connector
Th is supplies external power.
Connect the AC adaptor (sold separately) or DC +24 V power supply.
Connector : D-sub 9-pin plug with screw
lock
Input power supply : 5 A (Max. 8 A)
Inrush current
: 14 A or less
Pin Signal
1 +24 V
2 +24 V
3 +24 V
4 +24 V
5 NC
6 GND
7 GND
8 GND
9 GND
d Ground terminal
Th is ground terminal is the same potential as the frame and the ground side of the signal line.
When installing the interpolator unit, connect this terminal and the connected machine with a
ground wire.
Note
Establish a reliable connection between the interpolator unit and ground. If the ground connection is
unstable, proper performance may not be achieved.