Laserscale SET-HD100, Instruction Manual

Page: 54 / 74

SET-HD100
10
(E)
6
Mount the head unit
Fully tighten the screws semi-tightened in Step 4. Do not change position of head unit from position
adjusted in Step 5.
<Specifi cation>
See section 8 “Specifi cations.”
Aft er fully tightening the screws, pull out the axis alignment jig.
Th is completes the installation.
3-2. Connections
Notes
• Be sure to always turn off the power before connecting or disconnecting the connection cable. If the
cable is connected or disconnected while the power is on, the sensor light source may be damaged.
• Make sure the connections aft er scale unit and head unit installations are complete.
3-2-1. Items to be Prepared
• Connection cable (supplied)
• DC +24 V power supply or AC adaptor BP-24 (sold separately)
• USB cable: USB2.0 Type B (Th
e customer should procure the USB cable separately.)
3-2-2. Connection Procedure
1
Connect the head unit and interpolator unit
Check that the power is off , and connect the head unit and interpolator unit with the supplied
connection cable. Securely tighten the screws of the connection cable connectors so that the connectors
do not come loose during measurement.
2
Connect with the power supply
Connect the DC power cable to the interpolator unit.
3
Connect with the computer
Connect the USB cable.
Th is completes the connections.