Laserscale SET-HD100, Instruction Manual

Page: 47 / 74

SET-HD100
(E)
3
2. Names and Functions of Parts
2-1. Head Unit
2 Output connector
1 Laser emission position
1 Laser emission position
a Laser emission position
Th e laser beams are emitted from here.
Warning
Th e laser beams are hazardous to the human body. Never look into the laser emission areas while the
power is on. Also do not turn on the power before installation.
b Output connector
Th is outputs the signal of each sensor to the interpolator unit.
Connect the supplied connection cable.
Note
Be sure to always turn off the power before connecting or disconnecting the connection cable. If the
cable is connected or disconnected while the power is on, the sensor light source may be damaged.
2-2. Scale Unit
1 Reference point mark
<Scale surface>
Scale base
Scale
<Mounting surface>
a Reference point mark
Th e reference point of the scale is set here.
When this mark passes below the reference point detection sensor of the head unit, the reference point
signal is detected.