Laserscale SET-HD100, Instruction Manual

Page: 62 / 74

SET-HD100
18
(E)
7. Trouble Information
Check the following items and take the proper remedial actions when the status indicators of the
interpolator unit indicate an error or an alarm.
Symptom Cause Remedial action
Th e STATUS indicator lights
up or blinks red.
Self-calibration failed. See section 3-1 “Installation” and
section 4-1 “Measurement when
Performing Self-calibration,” and
perform installation again.
A SENSOR (1 to 6) indicator
lights up red. A level alarm or speed alarm has
occurred.
In case of a level alarm:
Th e sensor signal level has dropped.
a
Dropped due to dirtiness
See section 6-1 “Cleaning” and clean
the scale unit.
b
Th e installation position may not
satisfy the tolerance range.
See section 3-1 “Installation” and
section 8-2 “Installation Error
Range and Environmental and
Rotational Accuracy Conditions for
Guaranteeing Accuracy,” and check
the installation position.
In case of a speed alarm:
Th e maximum rotary response speed
was exceeded.
Use at the maximum rotary response
speed or less.
Th e POWER indicator is off . Th e power is not turned on. Check that power supply (+24 V) is
input. Check whether the fuse has
melted.
If performing the above actions does not resolve the trouble, contact our service department.