3.2 PRIMING THE UNIT AT INSTALL OR WITH NEW MINUTE PAK
A. Prime pump using the key.
Dispense concentrate until
product appears consistent.
B. Turn key back to the
to
(ON) position.
3.3 PRIMING THE UNIT AFTER DAILY FLUSH
A. Prime pump using the key. Prime for one (1) second.
B. Turn key back to the to
(ON) position.
3.4 PURGING THE WATER SYSTEM OF AIR
A. Turn key from the
(ON)
position to the
(FLUSH)
position.
B. Place a cup beneath the left most (when facing the machine)
dispensing nozzle and press the
PUSH
button until a clear
stream is observed.
C. Purge the remaining valves the same way, progressing to
your
right.
D. Turn the key back to the
(ON)
position.
E. Dispense a small amount from each valve until product is
visible in the stream. The dispenser is ready to operate.
3.5 SOLD OUT OPERATIONS
When the display shows
SOLD OUT
or
CHANGE PACKAGE
,
follow the loading procedures to change the package. Priming
will reset the
SOLD OUT
feature. It is important to prime
completely for the
SOLD OUT
feature to work correctly.
3.6 SETTING RATIOS
A. This process should only be performed during
startup, pump replacement or changing of brand.
B. Turn key to
(FLUSH).
C. Enter juice selection programming mode by
simultaneously pressing the and
#
buttons.
D. Toggle up or down to select juice type.
Press to scroll up. press
#
to scroll down.
E. Press
PUSH
button to set.
F. For non-standard brands, toggle to
“Other Custom”
(*see below) and simultaneously press the
and
#
buttons.
• The display will default to 5:1.
• The left button will decrease ratio by .25 ratio units.
• The right button will increase by .25.
*
*
*
*
* Other Custom
16
