1. INSTALLATION
1.1 SELECTING A LOCATION FOR THE DISPENSER
MAKE SURE THE LOCATION MEETS THESE REQUIREMENTS:
A. Select a location close to a properly grounded electrical outlet and water supply that meets the
requirements on the Specification page.
B. Ensure the location provides a minimum of four inches clearance on the sides and back of
dispenser.
11
!
WARNING
ENSURE PROPER VENTILATION AS FOLLOWS:
2-VALVE: INSTALL ON SUPPLIED LEGS. DO NOT SEAL TO THE COUNTERTOP. CONDENSER AIR IS DRAWN UP
THROUGH THE BOTTOM AND EXHAUSTED OUT THE BACK.
4-VALVE: INSTALL ON SUPPLIED LEGS OR SEALED TO THE COUNTERTOP USING CLEAR SILICONE R.T.V.
SEALANT (NOT PROVIDED). CONDENSER AIR IS DRAWN IN THROUGH THE BACK AND EXHAUSTED OUT
THROUGH THE TOP.
ADVERTENCIA
ASEGURARSE DE UNA VENTILACIÓN ADECUADA DE LA SIGUIENTE MANERA:
2-VÁLVULA: INSTALAR EN LAS PIERNAS SUMINISTRADOS. NO SELLE A LA ENCIMERA. AIRE DEL
CONDENSADOR SE ELABORA A TRAVÉS DE LA PARTE INFERIOR Y AGOTADO EL ESPALDA.
4-VÁLVULA: INSTALAR EN LAS PIERNAS SUMINISTRADOS O SELLADA A LA SUPERFICIE DE TRABAJO CON
CLARA R.T.V. SILICONA SELLADOR (NO INCLUIDO). AIRE DEL CONDENSADOR ES ASPIRADO A TRAVÉS LA
PARTE DE ATRÁS Y AGOTADO POR LA PARTE SUPERIOR.
AVERTISSEMENT
VEILLER À ASSURER LA VENTILATION APPROPRIÉE DE LA MANIÈRE SUIVANTE:
2-CLAPETS: FIXER SUR LES PATTES FOURNIES. NE JAMAIS SCELLER AU COMPTOIR. L’AIR DU
CONDENSATEUR EST TIRÉ VERS LE BAS ET ÉVACUÉ PAR L’ARRIÈRE.
4-CLAPETS: FIXER SUR LES PATTES FOURNIES OU SCELLER AU COMPTOIR À L’AIDE DE SCELLANT DE
SILICONE RÉSISTANT AUX VARIATIONS DE TEMPÉRATURE. L’AIR DU CONDENSATEUR EST TIRÉ VERS
L’ARRIÈRE ET ÉVACUÉ PAR LE DESSUS.
1.2 UNPACKING
A. Remove outer packaging.
B. Slide a corner of the dispenser (on plywood shipping base) over the edge of the counter and
remove shipping screw and washer.
C. Replace shipping screw and washer with a 3/8” x 16 stainless phillips truss head from
installation
kit.
D. Repeat for remaining corners.
E. Slide dispenser off of plywood shipping base.
1.3 FILLING THE DISPENSER WITH WATER
The dispenser is fitted with a filling tube on the compressor deck. The 4-Valve dispenser (only) has
a water bath drain located on the left side of the inner plate behind the splash plate. The water bath
overflow is located in the back center of the product compartment, behind the front panel plate.
A. Remove the two screws securing the grill over the compressor deck.
B. Remove the grill.
C. Remove the filling tube plug from the filling tube.
D. Open the front doors to the product compartment
4-VALVE ONLY
- Check that the drain is closed by gently turning the drain outlet clockwise. The
drain fitting threads in and out, and seals with o-rings.
E. Use a funnel or tubing and add water through the filling tube until you observe a trickle from the
overflow. you can see the overflow hole by looking through the peephole in the front plate with
the aid of a flashlight. The overflow will drain to the drip tray.
F. Replace the plug on the filling tube.
G. Replace the grill on the compressor deck and secure with the two screws.
