PORTION CONTROL
In this option, each valve can be individually programmed to dispense four different volumes. The
valve will dispense the programmed volume amounts when the corresponding button on the touch
sensor switch is activated.
• Place a vessel on the target located on the cup rest.
• Activate the program mode for that valve by simultaneously pressing the
”Small”
and
“Extra Large”
buttons.
• Place a glass on the target on the cup rest and press the corresponding button.
• Continue holding the button until the proper fill level is obtained.
• Use the same procedure to set the fill volume for other sizes.
• Push the
PUSH
button to exit the program mode.
The program will automatically store the last fill volume that was dispensed through the selected
button size before the program was exited.
• Follow the same procedures to set the fill volume for the remaining valves. Since the volume
setting are unique to each valve, each valve can have four different dispense volumes. For
example, Lemonade in valve position one could have a different dispense volume (i.e.
“Small”,
“Medium”
, etc) than Orange juice in valve position two.
4. CLEANING AND SANITIZING
4.1 GENERAL INFORMATION
Lancer equipment is shipped from the factory cleaned and sanitized in accordance with NSF
guidelines. After installation, it is the responsibility of the installer to clean and sanitize the dispenser
again. The operator of the equipment must provide continuous maintenance as required by this
manual and state and local health department guidelines to ensure proper operation and sanitation
requirements are maintained.
For optimum dispenser performance and highest drink quality, follow the instructions listed for
cleaning your dispenser. The instructions are also on the inside front cover of the dispenser.
Cleaning and sanitizing should be accomplished only by trained personnel.
18
