Lake Shore 350, User Manual

Page: 182 / 192

168 c
HAPTER
8: Service
Model 350 Temperature Controller
8.7.1 Default Values The factory defaults can be reset, and the user curves cleared, using the Factory Reset
menu. To access the Factory Reset menu, press and hold the
Escape key for 5 s. Once
the menu appears, set either Reset to Defaults or Clear Curves, or both, to Yes, then
highlight Execute and press
Enter .
Default values
Input Setup – General Default Interface Setup – General Default
Sensor type NTC RTD
Enabled USB
Sensor excitation 1 mV
Filter Off Interface Setup – IEEE Default
Input name Input A (B, C, D) IEEE Address 12
Temperature limit 0 K (Off) Interface Setup – Ethernet Default
Input units Kelvin DHCP On
Curve None Auto-IP Off
Input Setup –

Platinum/NTC RTD
Default Static-IP 192.168.0.12
Autorange On Static Subnet Mask 255.255.255.0
Current reversal On Static Gateway 192.168.0.1
Input Setup – Thermocouple
Input Option Card
Default Static Primary DNS 0.0.0.0
Room comp On Static Secondary DNS 0.0.0.0
Room cal Cleared Preferred hostname LSCI-350
Input Setup –

Capacitance Option Card
Default Web username user
Temperature coefficient Positive
Web password
Alarm Default
Output Setup Default Alarm Off
Output mode Closed loop PID (off for Output 3 and 4) Relay Default
Control input
Input A for Output 1; Input B for Output 2
none for output 3 and 4
Relay Off
Heater resistance 25
)
Keypad Locking Default
Power up enable Off Mode Unlocked
Heater out display Current Lock code 123
Setpoint ramping Off
PID/Manual Heater Power
(MHP) Output
Default
Display Setup Default Proportional (P) 50.0
Display mode Custom Integral (I) 20.0
Number of locations 2 (large) Derivative (D) 0.0
Location 1 source Input A Manual Output 0.000%
Location 1 units Kelvin Heater Default
Location 2 source Input B Heater range Off
Location 2 units Kelvin Setpoint Default
Location 3 source Input C Setpoint value 0.000 K
Location 3 units Kelvin Remote/Local Default
Location 4 source Input D Remote/Local Local
Location 4 units Kelvin Zone Settings – All Zones Default
Location 5 source Input A Upper boundary 0.000 K
Location 5 units Sensor Proportional (P) 50.0
Location 6 source Input B Integral (I) 20.0
Location 6 units Sensor Derivative (D) 0.00
Location 7 source Input C Manual output 0.000%
Location 7 units Sensor Range Off
Location 8 source Input D Ramp rate 0.100 K/min
Location 8 units Sensor Control input Default
Contrast 28
TABLE 8-1