Label FEED NAVIGATOR, User Manual

Page: 79 / 92

[
ERR-32
]
•
Recipe Execution Activity
•
An attempt is made to per
form the Daily Recipe but as of the afternoon, the
morning execution
has not been per
formed. T
o return to the Recipe Programming Activity
, press the
Prog./Start
key; to continue the Recipe execution, but not in “Daily” mode, press the
OK
key
.
[
ERR-33
]
•
Switching-On
•
This is displayed for 2 seconds at Switching-On when the Use T
ime of at least one Identification
Code is over 900.00 hours. The max. Use T
ime that can be stored by the equipment is 999.55
hours.
[
OV. LOAD
]
•
Recipe Execution Activity
•
Manual W
eighing Activity
•
W
eighing with Threshold
Activity
•
The T
otal W
eight has exceeded the value programmed in the Max. Capacity
Threshold
Preference, blocking equipment operation. To eliminate the error condition, unload the excess weight or press the
OK
key to return to the
Recipe Programming Activity
.
b
�
(steady or flashing)
•
In all Activities
•
This appears steady during the standard operation, when the value of the su
pply voltage is
correct. It appears flashing when the batter
y is running low and the power supply is less than
10Vdc. In this case, it is necessar
y to terminate the weighing operations quickly and recharge
the batter
y. The time available for terminating the weighing operations depend
s on the batter
y
used. If the value of the supply voltage goes down below 8.5Vdc, the equipme
nt switches of
f
automatically; in this case, it is necessar
y to recharge the batter
y immediately
.
[
L. BAT
]
•
In all Activities
•
This is displayed for 2 seconds at the Switching-On or during standard opera
tion, when the
value of the supply voltage is less than 8.5Vdc; after 2 seconds, the equipment
switches of
f
automatically
. T
o use the equipment it is necessar
y to recharge the batter
y.
[
H. BAT
]
•
In all Activities
•
This is displayed for 2 seconds at Switching-On or during standard operation,
when the value
of the supply voltage is greater than 32Vdc; after 2 seconds, the equipment s
witches of
f
automatically
. T
o use the equipment, the electric system of the mixer wagon and
of the tractor
must be checked by a car electrician.
[
PW FAIL
]
•
Recipe Execution Activity
•
I
f during the Recipe Execution Activity the equipment switches of
f accidentally due to
a voltage drop, the next time the equipment is turned on the [
PW. FAIL
] message
will appear for 3 seconds on the display to indicate that the equipment was automatically switched on after a voltage drop; after those 3 seconds the equipment will automatically return to the point it was in when the power interruption occurred. If the Power Output Preference (code 52) is set to Extractor
, press the
OK
key to
eliminate the error message [
TOLER.
] from the display
.
AppeNdiX A