Label FEED NAVIGATOR, User Manual

Page: 7 / 92

1.3 - CONNECTIONS
The equipment is connected (see Figure 5) with two connectors of the MS/MIL - C5015
series (see Figure 2). The 5 pole connector, identified by a blue label with the word
SENSOR written on it, is meant for connecting the sensor extension cable, identified by a
blue colored band. The 3 pole connector identified by a red labels with the word POWER/
ALARM written on it, is meant for connecting the supply voltage and alarm cable, identified
by a red colored band.
The equipment is provided with two other connectors: one for the connection of the
T-Data8 Plug device (T-DATA) and the other for the printer connection (PRINTER).
Other connectors can be installed when the equipment is preset for the connection with
Options.
t
Warning: before making the connections, make sure that the equipment and the
Optional devices (option) are switched off.
y
t
Warning: do not force the insertion between the connector of the cable and that of the
equipment because, if the two do not connect easily, they are probably incompatible.
Before inserting each connector, it is necessary to verify the type, the position and the
reference notch, as inserting the connectors incorrectly could cause serious damage to
the equipment. After having inserted the connector, screw down the metal fixing ring. To
disconnect the connector, unscrew the metal fixing ring and take the connector out by
holding it by the tip and not by pulling at the cable.
y
Figure 2
chApter 1