LMFC250 FINE CRUSHER MANUAL
7
Lubrication
7.2
Data for Lubricants, Hydraulic Fluids, Coolants etc.
Note
: Refer to Section 10 of this Manual for any Lubrication Material Safety Data Sheets.
The procedure that follows outlines the proper method for routinely and safely lubricating the Crusher.
•
Lubrication must not be carried out when the Crusher is running.
•
Ensure that the work area is clear of any material that may cause, or fuel, a fire.
•
Follow the manufacturer
’
s safety instructions when handling the lubricant, to prevent any injury to personnel.
•
Wipe the Crusher grease points down with a clean rag prior to lubrication.
•
Avoid over lubricating the Crusher. Refer to 7.4 Lubrication Schedule, below.
•
Always wipe off any excess grease.
7.1
Lubrication Safety and other precautions
7.3
Lubrication Points
The Crusher has seven (
7
) lubrication points, five (
5
) for the main bearings and crank and two (
2
) for the main pitman arm
bush.
Refer to the Figures below for the location of grease points.
Note: Access to the grease nipples is gained by removing the stainless steel top cover. To remove the cover, remove the two
(
2
) eye bolts and eight (
8
) Allen screws holding the cover to the top of the machine.
Five Grease points for Main Bearings & Crank
Two Grease Points for Pitman Arm
Fig 10. Grease points for the crusher main bearings & crank.
Fig 11. Grease points for crusher pitman arm bush.
5
5
5
34
