LMFC250 FINE CRUSHER MANUAL
Screw Slots
Pointer not midway of the
Screw Slot
Reversible Pointer Plate
Fig 5. Reversing the pointer plate.
Step 6
Using the supplied 46 mm spanner on the hex machined on the end of the shaft, turn the shaft back until the pointer is lined
up with the desired particle size, in mm, on the indicator plate. Use a portable shim (steel plate of appropriate thickness) as a
feeler gauge between the bottom edges of the jaw plates to confirm the setting of the jaw plates. The minimum jaw gap for this
machine is 2 mm.
Step 7
Remove the shim gauge from the Jaw Plates. With the supplied 46 mm spanner still on the hex on the shaft, turn in the clamp
block bolt and feel the serrations on the shaft and the clamp block meshing together as the bolt is tightened. If necessary, rock
the shaft slightly with the spanner to ensure the serrations mesh correctly. Nip the bolt up, not too tight and nip up the locknut.
Step 8
Turn the flywheel by hand to check that everything is correct and the jaw plates do not touch and that the gap has remained
correct. Reinstall the covers and reconnect the power to crush a sample of material to determine the correct settings for the
desired particle size.
Note:
Different types of material may crush to variable particle sizes for the same setting. Therefore, fine tuning of the jaw gap
may be necessary for different materials.
5
5
5
28
