LMFC250 FINE CRUSHER MANUAL
Step 2
To adjust the gap, first remove the hopper and flywheel cover and turn the flywheel until top dead centre of the eccentric shaft and jaw
movement is found (i.e. jaw plates closest together).
Step 3
Mark a line on the top of the flywheel, adjacent to the grease nipple, with a permanent marker. This will make it quicker to find top dead
centre for future adjustments.
Step 4
Using the supplied 46 mm spanner, undo the locknut of the clamp block bolt and then undo the bolt at least four (4) full turns, to enable
Locknut
Clamp Block Bolt
Jaw Gap Adjustment Shaft
Fig 2. Releasing the bottom adjustment shaft.
5
5
26
6.5.2
Incorrect particle size being produced
Warning: Personnel Danger/Hazard –
Isolate the machine from all power before making any
adjustments or jaw plate inspections. Failure to comply may result in personal injury or damage to
the machine and void the warranty.
Step 1
Isolate the machine from all power, as stated above.
Note: Machinery Damage/Hazard –
The minimum jaw gap is 2 mm.
