Always follow proper procedures for going down slopes and for braking on slopes as described in
this manual. Check the terrain carefully before you start down any slope. Shift your weight
backward. Never go down a slope at high speed. Avoid going down slope at an angle that would
cause the vehicle to lean sharply to one side. Go straight down the slope where possible.
Never attempt to turn the ATV around on any slope until you have mastered the turning technique
described in this manual on level ground. Avoid crossing the side of a steep slope if possible.
Always check for obstacles before operating in a new area. Never attempt to operate over large
obstacles, such as large rocks or fallen trees. Always follow proper procedures when operating
over obstacles as described in this manual.
Always be careful when skidding or sliding. Learn to safely control skidding or sliding by
practicing at low speeds and on level, smooth terrain. On extremely slippery surfaces, such as
ice, go slowly and be very cautious in order to reduce the chance of skidding or sliding out of
control.
Never operate an ATV in fast flowing water or in water deeper than that recommended in this
manual. Remember that wet brakes may have reduced stopping ability. Test your brakes after
leaving water. If necessary, apply them several times to let friction dry out the linings.
Always use the size and type tires specified in this manual. Always maintain proper tire pressure
as described in this manual.
Never modify an ATV through improper installation or use of accessories.
Never exceed the stated load capacity for an ATV. Cargo should be properly distributed and
securely attached. Reduce speed and follow instructions in this manual for carrying cargo. Allow
greater distance for braking.
6
Summary of Contents for MXU 500
