About Calibration Sequence
3-9
965X Operation Manual
About Calibration Sequence
The machine has been calibrated at the factory. References may drift during operation. To com
-
pensate for these change, use the calibration routines under the
Calibration Tab.
Note:
It is recommended to
verify the Tool Config
settings before calibrating the
plunge
cut (
Z-Axis
). This is a global calibration. Therefore, by calibrating, other tools
may be out of calibration. For directions on how to use the configuration menus,
See “About the Tool Config Tabs” on page 2-29
To help identify tools that need
to be calibrated, view
Tool Path Review
.
See “About the Tool Path Preview Test
Screen” on page 2-32 .
Important:
It is crucial to calibrate or verify the settings in the order described in this
section. If the steps are not followed in the correct order, all calibrations
may suffer.
• See “Step 1: Check the Carriage Location” on page 3-10
• See “Step 2: Calibrate the Stops” on page 3-11
• See “Step 3: Calibrate the Tools” on page 3-12
• See “Routers: How to Isolate and Calibrate a Specific Router” on page 3-18
Summary of Contents for 965X
Page 103: ......
