Installing the Inverter/Charger
This guide for use by qualified personnel only.
Connecting the AC Output Wires
To make the AC output wiring connections:
1. Remove one of the AC knockouts from the front or side
of the unit. Do not leave the knockout inside the wiring
compartment.
2. Install a strain-relief clamp in the AC knockout and run
the AC wiring through the strain-relief clamp.
3. Strip approximately 2 inches (50 mm) off the jacket from
the AC cable and separate the wires.
4. Using a 1/4" blade slot screwdriver, loosen the terminal
screws on the AC output terminals. Do not remove the
screws.
5. Connect the line and neutral wires to the output terminals
(labeled AC Output on the terminal block, Figure 7 on
page 2
8
) as follows:
6.
Tighten the terminal screws. Leave some slack wire
inside the wiring box.
7.
Connect the ground wires to a free position on the ground
bus, Figure 7 on page 2
8
. If solid ground wire is being
used, the wire can be connected directly under the screw
heads. If stranded ground wire is being used, ring
terminals must also be used.
EQUIPMENT DAMAGE
Do not connect the output of the inverter to any AC source.
Failure to follow these instructions can damage the unit and/or damage
other equipment.
IMPORTANT:
The applicable installation code may not allow you to run
the AC input and AC output wiring through the same AC knockout.
$XWR3RZHU
Terminals
Line for
Dual Output
Lines for
Single Output
N2
Neutral 2
Unused
L2
Line 2
Unused
N1
Neutral 1
Neutral
L1
Line 1
Line
$XWR3RZHU
Terminals
Lines for
Output
N
Neutral
L
Line
Summary of Contents for 091-269-12-2000
Page 2: ......
Page 31: ...1 Blank Page for future use...
