Planning Preparations
Installation Tools and Materials
Tools
You will need the following tools to install the
$XWR3RZHU
and the battery temperature sensor.
❐
Wire stripper
❐
Crimping tools for fastening lugs and terminals on DC
cables
❐
Phillips screwdriver: #2
❐
Slot screwdriver (1/4" wide blade max.)
❐
Needle-nose pliers
❐
Wrench for DC terminals: 9/16"
NOTE
: For a list of tools and materials required to install the
network, refer to the
.
DQEXV6\VWHP,QVWDOODWLRQ*XLGH
1.Screw length depends on wall material and thickness.
Materials
You will need the following materials to complete your
installation:
Strain-relief clamp(s) for AC cables (not provided): 3/4"
and/or 1"
DC battery cables
Lugs for DC cables (for 3/8" stud size)
Copper wire for DC grounding: No. 8 AWG. See “DC
Grounding” on page 1
7
Lugs for DC grounding cable (for 1/4" stud size)
AC and DC disconnect switches and overcurrent
protective devices and connectors as required. See
page 16.
AC output and input wire. See Figure 3 on page .
If the AC ground wire is stranded, each ground wire
requires a ring terminal
Six 1/4" pan-head steel screws
1
to mount the unit to a
wall
Summary of Contents for 091-269-12-2000
Page 2: ......
Page 31: ...1 Blank Page for future use...
