45
Installing the Inverter/Charger
After initialization, observe that none of the lights on the
front panel should remain illuminated.
Press the
INVERTER ENABLE
button.
Verify that the
INVERTER ENABLED
LED is on.
Connect the
$XWR3RZHU
to the test load by closing the
AC breaker that controls the circuit that the test load is
connected to. If the light bulb illuminates, the Invert
mode is working.
Press the
INVERTER ENABLE
button to disable the
inverter.
Verify that the
INVERTER ENABLED
LED is off.
Testing in Charge Mode and AC Bypass Mode
1. Close the AC supply breaker to supply AC power to the
unit.
To verify that the
$XWR3RZHU
starts charging:
2. After a few seconds, verify that the
AC IN/CHARGING
LED on the front panel is turned on (indicating that the
batteries are being charged).
To verify that
$XWR3RZHU
correctly switches to Bypass
mode:
3. Disable the AC source and disable inverter mode by
pressing the
INVERTER ENABLE
button.
4. Connect the test load to the AC output connection of the
unit.
5. Enable the AC source and the test load should turn on
after ten seconds.
Installation Complete
Your installation is now complete. The
$XWR3RZHU
inverter/
charger is ready for use.
The preceding tests use a light test load (a light bulb) as a test
case. If you encounter problems when using a load over 1000
watts (for example, a hair dryer or microwave), see the
troubleshooting information in the
$XWR3RZHU
2000 & 3000
Inverter/Charger Owner’s Guide.
Summary of Contents for 091-269-12-2000
Page 2: ......
Page 31: ...1 Blank Page for future use...
