Specifications
This guide for use by qualified personnel only.
NOTE
: All charging specifications are at nominal conditions: ambient temperature of 77 °F (25 °C), 120 VAC, 60 Hz input, unless
otherwise specified.
Charger Specifications
$XWR3RZHU
$XWR3RZHU
Charging method
Three-stage charge (Bulk, Absorption, Float)
Two-stage charge (Bulk, Absorption)
The default charging method is three-stage.
Without a battery temperature sensor
Three settings with the following temperature values:
Cool 50 °F (10 °C) / Warm 77 °F (25 °C) / Hot 104 °F (40 °C)
The default setting is Warm and it can only be changed by the factory, a dealer, or a service centre.
With a battery temperature sensor (included)
The temperature compensation coefficients on a
12-volt battery are as follows:
Flooded: 27 mV × (25 °C – BTS °C)
Gel: 27 mV × (25 °C – BTS °C)
AGM: 21 mV × (25 °C – BTS °C)
The temperature compensation coefficients on a
24-volt battery are as follows:
Flooded: 54 mV × (25 °C – BTS °C)
Gel: 54 mV × (25 °C – BTS °C)
AGM: 42 mV × (25 °C – BTS °C)
Output current (maximum)
100 ADC
150 ADC
Output voltage
12 VDC
12 VDC
Output voltage range
5–16 VDC
5–16 VDC
Equalization cycle
Automatic, Manual by
.
anbus SCP
Automatic, Manual by
.
anbus SCP
Optimal charging efficiency
> 85%
> 85%
AC input power factor (at full charge rate)
> 0.98
> 0.95
AC input current
24A max. (including pass-thru)
24A max. (including pass-thru)
AC input voltage
120 VAC
120 VAC
AC input voltage range
85–140 VAC
85–140 VAC
Dead battery charge voltage
> 5 VDC
> 5 VDC
Supported AC input types
Single input (up to 30 amps)
Split phase (up to 30 amps per line)
Dual input (up to 30 amps per line)
72
Summary of Contents for 091-269-12-2000
Page 2: ......
Page 31: ...1 Blank Page for future use...
