Kubota ME5700, Workshop Manual

Page: 35 / 508

ME5700, WSM GENERAL
G-18
Cleaning Water Separator (CABIN Type)
1. Close the fuel cock (1).
2. Unscrew the retainer ring (2) and remove the cup (3), and
rinse the inside with kerosene.
3. Take out the element and dip it in the kerosene to rinse.
4. After cleaning, reassemble the water separator, keeping out
dust and dirt.
5. Bleed the fuel system. (See page G-34.)
[3] CHECK POINTS OF EVERY 50 HOURS
Checking Engine Start System
A
Do not allow anyone near the tractor while testing.
A
If the tractor does not pass the test, do not operate the
tractor.
B
Preparation before testing.
1. Place all shift lever and hydraulic levers in the "NEUTRAL".
2. Set the parking brake and stop the engine.
B
Test 1 : Switch for the shuttle shift lever.
1. Sit on operator's seat.
2. Shift the shuttle shift lever to the forward or reverse position.
3. Depress the clutch pedal fully.
4. Disengage the PTO clutch control lever.
5. Pull out the engine emergency stop knob and turn the key to
"START" position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
B
Test 2 : Switch for the PTO clutch control lever.
1. Sit on operator's seat.
2. Engage the PTO clutch control lever.
3. Depress the clutch pedal fully.
4. Shift the shuttle shift lever to the neutral position.
5. Pull out the engine emergency stop knob and turn the key to
"START" position.
6. The engine must not crank.
7. If it cranks, inspect the safety switch.
(1) Fuel Cock (6) Spring
(2) Retainer Ring (7) Red Float
(3) Cup
(4) O-ring A : CLOSE
(5) Element
0000003166E
(1) Hydraulic Shuttle Shift Lever (3) PTO Clutch Lever
(2) Clutch Pedal
0000002270E
KiSC issued 04, 2006 A