Kubota ME5700, Workshop Manual

Page: 34 / 508

ME5700, WSM GENERAL
G-17
Changing Transmission Fluid
A
Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom
of the transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (3).
Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page G-8.)
4. After running the engine for a few minutes, stop it and check
the oil level again; add oil to prescribed level.
Changing Front Axle Case Oil
1. To drain the used oil, remove the right and left drain plugs (2)
and filling plug (1) at the front axle case and drain the oil
completely into the oil pan.
2. After draining, reinstall the drain plugs (2).
3. Remove the right and left breather plugs (3).
4. Fill with the new oil.
5. After filling, reinstall the filling plug (1) and breather plugs (3).
A
Use KUBOTA SUPER UDT fluid or SAE80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT" (See
page G-8.)
Transmission fluid Capacity
ROPS
40.0 L
42.3 U.S.qts
35.2 Imp.qts
CABIN
43.0 L
45.4 U.S.qts
37.8 Imp.qts
(1) Drain Plug A : Oil level is acceptable within
(2) Oil Inlet the range.
(3) Dipstick
0000003062E
Front axle case oil Capacity
8.0 L
8.5 U.S.qts
7.0 Imp.qts
(1) Filling Plug (3) Breather Flug
(2) Drain Plug
0000003063E
KiSC issued 04, 2006 A