Kubota ME5700, Workshop Manual

Page: 221 / 508

ME5700, WSM TRANSMISSION
3-S23
Shuttle Clutch Pack
1. Remove the internal snap ring (1), and then take out the
pressure plate (3), the clutch discs (4) and steel plates (6) and
(14).
2. Remove the external snap ring (7) using a shuttle clutch
compression tool (see page G-49), and take out the springs
(9) and piston (13).
(When reassembling)
A
When installing the internal snap ring (1) to the clutch body,
align its split portion to the notched portion of clutch body.
A
Replace the D-ring (11) with new one.
A
Apply transmission fluid to the D-ring (11), and take care not
to damage it.
A
Install 2 pieces of thin steel plate to the piston side.
If there is the 3 pieces thin steel plate, the 3rd thin steel plate
is put in to the internal snap ring (1) side.
A
Assemble the steel plates with rubber (5) and steel plates
without rubber (14) alternately, and steel plates are built in so
that the part of rubber is not corresponding to the part of the
hole.
A
Build in outside plate (15) with rubber of plate (6) so as not to
come in succession.
A
Thing to attach belleville spring (2) in the direction of figure.
A
Confirm the moving of the piston (13) smoothly when pressure
air at 0.5 to 0.6 MPa (5 to 6
, 72.5 to 87 psi) is sent to
clutch pack.
(1) Internal Snap Ring (10) O-ring
(2) Belleville Spring (11) D-ring
(3) Pressure Plate (12) Clutch Body
(4) Clutch Disc (13) Piston
(5) Rubber (14) Steel Plate (without rubber)
(6) Steel Plate (with rubber) (15) Steel Plate (with rubber)
(7) External Snap Ring A : Front Side
(8) Thrust Collar R : R Side
(9) Spring F : F Side
0000002751E
KiSC issued 04, 2006 A