gemino
52
CONFIGURATION PARAMETERS
DECODER CONTACT-ID
FIFTH STEP
Zone code selection
In this table is allowed to set zone code associated with the event previously
programmed. It’s possible to add a new code by pressing the button “New
Zone”. Selecting a code from the table, it can be modified by pressing the
button “Modify Zone” or it can be deleted with the button “Delete Zone”. The
use of default code is allowed by pressing the button “Default Contact-ID” and
selecting the desired events from the list. Up to 100 zone can be added.
Description:
It is the SMS message or email associated with the Contact ID packet
Zone code:
It is the number of the partition associated with the event.
Voice message:
It is the voice message associated with the Contact-ID packet.
Is now allowed to proceed with the insertion of the optional features pressig
the button “Forward” or even close the programmation pressing the button
“Output”. (
PART D
).
OUTPUTS
gemino
provide two outputs to signal internal events. These outputs con be
activated with a remote-control by means of the identification of the caller (CLIP
function).
Output polarity:
Set the output as Normally Open or Normally Closed
Type:
Bi-stable, this output follows the state of the corresponding event; Mono-
stable, this output is activated for a programmed time (ON time) when a specific
event come true, then goes off. The outputs activated by the CLIP function are
setted forcedly as Mono-stable, even if they are programmed as Bi-stable.
ON Time:
Shows the duration, in seconds, of the activation time of a mono-stable
output when an event comes on.
Event table:
In this table is allowed to link each event to an output.