gemino
46
CONFIGURATION PARAMETERS
VOICE MESSAGES OPTIONS
Call all numbers:
If this option is selected the voice messages will be sent to all
programmed numbers, otherwise to the first number that answer.
Confirm call result:
The receiver of the call, when this options is selected, has to
press the ’ ’ button to make a confirmation, otherwise the
gemino
will consider
the call a failure and will proceed to call the following number
Clear call queue on disarming event:
If the central station send an Contact-ID
event to disengage, all the call in the queue will be blocked
Call attempts:
Set the number of attempt to make a call towards a programmed
number prior to cancel the message (when a confirmation is not received).
Iterations:
Set the number of repetition of the voice message during a single call
Call confirmation message:
This voice message is reproduced at the end of all
the others message and can be used as guideline (e.g. to tell the user to press ‘
’ to confirm the reception of the message).
LINE OPTIONS
Digits to remove:
This parameter must be used if
gemino
is connected downstream
of a telephone switchboard and represents the number of figures (typically 1)
which must be removed at the start of the number if the call is forwarded via
GSM.
PSTN fault delay:
This is the minimum time, expressed in minutes before
gemino
generates the PSTN line failure (default 0).
Simulated line delay:
This is the minimum time, expressed in minutes during which
gemino
provides the simulated telephone line following the detection of the PSTN
line failure (default 15).
Dial Tone:
Select the country to set the tone type generated on the simulated line
PINS
User:
insert user PIN
Installer:
insert installer code