Krone KWT 1600, Original Operating Instructions, Page: 62 / 96

9 Driving and transport
9.2 Reducing the transport width
62
KWT 1600
Original Operating Instructions 150000169_04_en
ü
The stop cocks on the hydraulic hose lines are closed, refer to page 53 .
ü The transport width is reduced, refer to page 62 .
ü
Soiling and crop residue have been removed from the machine, in particular from the
lighting and identification elements.
9.2 Reducing the transport width
KW000-045
To reduce the transport width, position the outer running wheels (1) under the rotors in the
upper bore of the axle support (2) (flat spreading angle).
„
Remove linch pin (3).
„ Pull out the bolt (4).
„
Swivel the running wheel (1) down until the top bore of the axle support (2).
„ Push the bolt (4) in and secure it with the linch pin (3).
9.3 Parking the machine
WARNING
Risk of injury due to the unsecured machine rolling away
If the machine is not secured against rolling away when it has been switched off, there is a
risk of people being injured by the machine rolling away in an uncontrolled manner.
„ Secure the machine against rolling using wheel chocks.
„ Park the machine on a stable, horizontal and even surface.
„
Bring the machine into transport position.
„
Set the control units to the float position.
„
Switch off the tractor engine, remove the ignition key and take it with you.
„
Bring the support jack in support position, refer to page 54 .
„ Remove the power cable for the operation panel.
„
Disconnect the road lighting plug, refer to page 49 .
„ Loosen the safety chains of the universal shaft on the tractor side, decouple the universal
shaft and place it on the support provided for this purpose.
„
Depressurise the tractor hydraulics.
„ Disconnect the hydraulic hose lines and hook them into the support at the machine.