Krone KWT 1600, Original Operating Instructions, Page: 46 / 96

7 Start-up
7.2 Connecting machine to tractor
46
KWT 1600
Original Operating Instructions 150000169_04_en
The machine is equipped with Cat. II centring pivots for the three-point linkage.
„ The tractor lower links must always be installed so that the lifting points of the lower links are
all at the same distance from the ground.
„
Fix the lower links using retaining chains or retaining rods to prevent the machine swinging
to the side during transport or turning.
7.2 Connecting machine to tractor
NOTICE
Damage to the machine caused by a collision with the tow coupling
Depending on the type of tractor, the top link of the tractor and/or the universal shaft of the
machine may collide with the tow coupling and damage the tractor and/or the machine.
„
If necessary, remove the tow coupling. For additional information, please refer to the
tractor manufacturer's operating instructions.
ü The safety device, which prevents unauthorised use, has been removed, refer to page 51 .
1
6
5
3
4
4
3
2
KW000-027
„ Connect the machine according to the operating instructions of the tractor manufacturer to
the lower links (1), raise it slightly and secure it.
WARNING! Increased risk of injury! Ensure that there is no one between the tractor and the
machine while connecting the machine (especially while driving the tractor backwards).
„
Park the machine on the support jack (1).
„
Shut down and safeguard the machine, refer to page 25 .
„ Pull the linch pin (5).
„
Pull out the bolt (6).
„ Mount the top link (3) with the bolt on three-point hitch (4) and secure with the linch pin (5).