Krone KWT 1600, Original Operating Instructions, Page: 40 / 96

6 Initial operation
6.1 Checklist for initial operation
40
KWT 1600
Original Operating Instructions 150000169_04_en
6 Initial operation
This chapter describes assembly and adjustment work on the machine which may be carried
out by qualified technicians only. Here, the notice “Personnel qualification of technicians”
applies,
refer to page 14 .
WARNING
Risk of injury due to non-observance of relevant safety notices
If the relevant safety notices are not observed, persons may get seriously injured or killed.
„ To avoid accidents, the basic safety instructions must be read and observed, refer to
page 13 .
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
„
The safety routines must be read and observed to avoid accidents, refer to page 25 .
WARNING
Risk of injury or damage to the machine due to faulty initial operation
If the initial operation is carried out incorrectly or incompletely, the machine may present
defects. As a result, people may be injured or killed or the machine may be damaged.
„
Initial operation must only be carried out by authorised technicians.
„
Read in full and observe the “Personnel qualification of technicians”, refer to page 14 .
WARNING
Risk of injury due to the unsecured machine rolling away
If the machine is not secured against rolling away when it has been switched off, there is a
risk of people being injured by the machine rolling away in an uncontrolled manner.
„
Secure the machine against rolling using wheel chocks.
6.1 Checklist for initial operation
ü
The machine is mounted according to assembly instructions of the machine.
ü
All the screws and nuts have been checked to make certain they are tight and tightened to
the specified tightening torques,
refer to page 69 .
ü
The safety devices are mounted and checked for completeness and damage.
ü
The machine is fully lubricated, refer to page 79 .
ü
The oil level has been checked for all gearboxes, refer to page 77 .
ü The tractor corresponds to the machine requirements, refer to page 35 .
ü
The universal shaft length has been checked and adjusted, refer to page 41 .
ü
The hydraulic system has been checked for leaks.
ü The road travel lighting has been checked for function and cleanliness, refer to page 49