Krone KWT 1600, Original Operating Instructions, Page: 69 / 96

Maintenance – General 11
Tightening torques 11.2
KWT 1600
Original Operating Instructions 150000169_04_en 69
Components
Touch up damaged paint and preserve un-
coated areas with rust protection agent
Check that all moveable components move
freely. If required, dismount, clean, grease and
remount.
Park the machine in a weatherproof and dry
location which is not in close proximity to cor-
rosive substances
Protect the tyres against external influences
such as oil, grease or direct sunlight
Move the machine every 2 months
11.1.3 Maintenance – once after 10 hours
Components
Check tyre pressure refer to page 74
Retightening wheel nuts refer to page 74
Tighten screws/nuts on the machine refer to page 69
Check screws on the tines refer to page 72
11.1.4 Maintenance – every 50 hours
Components
Check tyre pressure refer to page 74
Retightening wheel nuts refer to page 74
Tighten screws/nuts on the machine refer to page 69
Check screws on the tines refer to page 72
11.1.5 Maintenance – Every 1000 hours
Changing oil
Main gearbox refer to page 77
11.2 Tightening torques
Deviating tightening torques
All screw connections must in general be tightened with the listed tightening torques following.
Deviations from the tables are marked accordingly.
Metric thread screws with control thread
INFORMATION
The table does not apply to countersunk screws with hexagon socket in case the countersunk
screw is tightened via hexagon socket.