Settings
261
Pos: 50.45 /Ü berschriften/Ü berschriften 2/A-E/EEinstellung der automatischen R ollbodenabschaltung @ 116\mod_1341208553537_78.docx @ 1021010 @ 2 @ 1
15.3
Adjusting the Automatic Floor Conveyor Stop
Pos: 50.46 /Abkürzungen /Abkürzung en spr achneutral/R undballenpr essen/Forti ma V 1500 (MC) / V 1800 (MC)_sprachneutr al @ 226\mod_1392720827776_0.docx @ 1826878 @ @ 1
Fortima V 1500 (MC) / V 1800 (MC)
Pos: 50.47 /BA/Ei nstellungen/R undball enpresse/Bil d R ollbodenabschal tung ei nstellen @ 74\mod_1309241717975_78.docx @ 660349 @ @ 1
VP-7-075
a
1
4
2
6
5
3
Fig. 217
Pos: 50.48 /BA/Ei nstellungen/R undball enpresse/Roll bodenabschaltung ei nstellen @ 74\mod_1309243109795_78.docx @ 660377 @ @ 1
When the tailgate is opened, the claw coupling (4) is activated by the cable (1) and linkage (2)
and the floor conveyors are switched off.
When switched on, dimension a to the side wall (6) must be approximately 22 mm.
Setting:
• Loosen the counter nut (3).
• Remove the bolt.
• Turn the U bar (5) until dimension a is reached.
• Install the bolt and counter net and retighten.
Pos: 50.49 /BA/Ei nstellungen/R undball enpresse/Bil d Schalteinstell ung en @ 74\mod_1309243333386_78.docx @ 660445 @ @ 1
VP700025
Fig. 218
Pos: 50.50 /BA/Ei nstellungen/R undball enpresse/Schalteinstell ung @ 74\mod_1309243498008_78.docx @ 660473 @ @ 1
The pressing force of the spring by the pull cable can be adjusted with the nuts (2).
When the tailgate is closed, dimension b must be approximately 250 mm.
To adjust switching, follow these steps:
• When the rear wall is closed, tension on the cable (3) must be slightly relieved and the
claws must be engaged. The cable length can be adjusted on the bar (4).
• With the rear wall slightly opened, adjust the nut (1) so that the roller (5) closes off flush with
the tip of the slotted link (6).
Note
The tip of the slotted link (6) must not be under the roller (5) when the rear wall closes.
Pos: 50.51 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1