KROHNE OPTISYS SLM 2100, Handbook, Page: 53 / 88

OPERATION
5
53
OPTISYS SLM 2100
www.krohne.com 01/2017 - 4002737304 - MA OPTISYS SLM 2100 R04 en
B3, logbooks
B4, information
5.6.3 Menu C, setup
C1, measuring
B2.2 B2.2 B2.2 B2.2 ADC value This menu shows the raw ADC value of the sensor.
B2.3
B2.3 B2.3
B2.3 sensor temperature This menu shows the actual temperature of the sensor.
B2.4 B2.4 B2.4 B2.4 electr. temperature This menu shows the actual temperature of the mainboard.
B2.5 B2.5 B2.5 B2.5 sensor voltage This menu shows the actual voltage of the sensor in volt.
Menu level Designation / function Settings / descriptions
This menu groups several functions which allow to display the corresponding actual reading.
B3.1
B3.1 B3.1
B3.1 status log Log for information, errors and warnings.
Menu level Designation / function Settings / descriptions
This menu groups several other menus which contain device specific information.
B4.1 B4.1 B4.1 B4.1 device serial no. This menu shows the serial number of the device.
B4.2
B4.2 B4.2
B4.2 mainboard This menu gives information about the mainboard.
•
First line: ID No. of the circuit board
•
Second line: software version
•
Third line: production date
B4.3
B4.3 B4.3
B4.3 sensor electronic This menu gives information about the sensor electronic.
•
First line: ID no. of the sensor
•
Second line: software version
•
Third line: production date
B4.4 display This menu gives information about the display.
•
First line: ID no. of the sensor
•
Second line: software version
•
Third line: production date
Menu level Designation / function Settings / descriptions
This menu groups several other menus in which the measuring functions can be set.
C1.1 measuring function This menu shows the different measurement functions: "level", "profile",
"zonetracking" and "manual operation". For further information refer to
Measuring function
on page 61
C1.2 measuring mode This menu shows the different measurement modes of the level
measurement and can be switched from "depth" to "height".
C1.3 definition fluff This menu shows the concentration of the fluff and can be set (this menu is
displayed only if "level" or "manual operation" is selected in C1.1).
Default: 0.5 g/l
C1.4 def. sludge blanket This menu shows the concentration of the sludge blanket and can be set
(this menu is displayed only if "level", "zonetracking" or "manual operation"
is selected in C1.1). Default: 5 g/l
C1.5 hysteresis This function allows to set the hysteresis value of the zone tracking mode.
(this menu is displayed only if "zonetracking" is selected in C1.1).
Range: 0
…
5 g/l; Default: 0 g/l
Menu level Designation / function Settings / descriptions