KROHNE OPTISYS SLM 2100, Handbook, Page: 43 / 88

OPERATION
5
43
OPTISYS SLM 2100
www.krohne.com 01/2017 - 4002737304 - MA OPTISYS SLM 2100 R04 en
5.1 Start-up and general remarks for configuration
Steps for starting up the device:
• Switch the power on
• Configure the device
• Start measurement
DANGER!
In order to avoid injuries or damage of the device or plant equipment the device shall only be
operated with both doors properly closed and locked. The device also has to be properly
mounted and all cable feedthroughs have to be properly tightened or plugged, if unused.
WARNING!
In general, the device may only be installed, commissioned, operated and maintained by properly
trained and authorised personnel.
WARNING!
To avoid damages to the equipment please make sure that power up of the meter takes place
above 0
°
C / +32
°
F. Once power is connected, the internal heater will than keep the electronics
from freezing.
WARNING!
The device starts up / restarts automatically as soon the power is switched on.
INFORMATION!
If the ambient temperature is below 4
°
C / +39
°
F, keep the sensor in the medium to avoid
attachment of ice on sensor. Set start position 30 cm / 1 ft below the water surface.
INFORMATION!
Ensure that the sensor transportation protection is removed before starting-up the system.
INFORMATION!
To install the meter in the best way, follow the steps described below.