kozy heat Dassel DSL-36-RF, Installation And Operation Manual

Page: 56 / 69

DSL-RF-36 REMOTE RECEIVER FUNCTIONS (cont.)
FIRST USE OF TRANSMITTER:
STATUS ACTION
Begin communication between transmitter and
receiver / valve. Move LOCAL/REMOTE Switch to LOCAL position for at least two seconds; then move
switch to the REMOTE position.
Transmit unique code. Press Fan or Flame key within 30 seconds.
Confirm recognition between transmitter and
receiver valve. Observe LED turns on for one second.
Chose REMOTE or LOCAL operation. Move LOCAL/REMOTE switch to LOCAL or leave in REMOTE.
OPERATION IN THE REMOTE POSITION:
AUTO Mode
With the control in the AUTO mode, the flame in the main burner will turn on, off, or change height based on the heat needed to maintain the set temperature.
STATUS ACTION
Set to AUTO. Press MODE button until mode is AUTO.
Change set temperature. Press UP or DOWN key to change temperature.
Flame. Automatically changes.
Fan. Automatically changes.
To set Delay Timer. Press TIME key followed by either UP or DOWN arrow key.
CAUTION: PROPERTY DAMAGE HAZARD. Excessive heat can cause property damage. In AUTO Mode, the main
burner will cycle indefinitely to maintain the set temperature. Keep the transmitter in a heated living space to make sure
the main burner is not on continuously.
ON Mode
With the control in the ON mode, the flame and fan levels and the delay timer are changed with the UP and DOWN arrow keys.
STATUS ACTION
Set to ON. Press MODE button until mode is ON.
Flame. Press FLAME button and press UP or DOWN arrow keys to change flame height.
Fan. Press FAN button and press UP or DOWN arrow keys to change fan speed.
Delay Time. Press DELAY TIMER button and press UP or DOWN key to change timer.
OFF Mode
The flame in the main burner will turn off and the
room temperature will be displayed in the remote
window.
Press MODE until mode is OFF.
Operation in the LOCAL Mode. NOTE:
Remote/Local switch on the receiver/valve must be in the LOCAL position.
FAN
Flame height and fan speed both go to the highest
position.
In LOCAL mode, to turn fan ON/OFF, rotate manual knob from ON to PILOT position.
OTHER FUNCTIONS:
Change between Fahrenheit and Celsius
temperature units. Press UP and DOWN arrow keys at the same time and hold for at least three seconds.
Fan override during AUTO Mode. Press FAN button, and press UP or DOWN arrow key to change the fan speed.
Disable/enable thermostat function in the AUTO
Mode. Press the TIME, DOWN and FLAME arrow keys at the same time and hold for at least three
seconds.
PAGE 55