IMPORTANT:
On the initial use of the transmitter, a recognition operation is required between
the receiver / valve and the transmitter.
1. Turn gas control knob to the
PILOT
position.
Move
LOCAL / REMOTE
switch to the
LOCAL
position
for at least two (2) seconds, then
move switch to the
REMOTE
position.
2. Press
FAN
or
FLAME
button
on the transmitter within thirty
(30) seconds of the switch
change.
DSL-RF-36 LIGHTING AND SHUTDOWN (cont.)
The
LED
will blink, indicating that the transmitter will now work with the receiver / valve. If the
switch stays in the
REMOTE
position, the TR8220A Transmitter will control the main valve, flame
modulation level and fan control.
If the
LOCAL / REMOTE
switch is in the
LOCAL
position, the receiver / valve will be at the highest
setting.
LOCAL SETTING:
Turn control knob clockwise to the
PILOT
position.
REMOTE SETTING:
The TR8220A transmitter can shut off the main burner and fan. However, the
control is still „ON‟ and a command from the transmitter can turn on the main burner and fan.
1. Open lower grill to access the gas valve & controls.
2. Turn gas control knob clockwise to the
OFF
position. This closes the main gas and safety valves.
The transmitter cannot turn on the main burner or the fan.
TURN THE BURNER OFF
TURN THE SYSTEM OFF
NOTE: This control valve has an interlock device. If pilot has been turned off, it
cannot be relit until the thermocouple has cooled, (approximately 60 seconds).
INITIAL USE OF TRANSMITTER
WITHIN
30 SECONDS
2 SECONDS
OR
PRESS
1.
2.
3. Turn gas control knob to the
ON
position.
NOTE: If the manual switch is in the LOCAL position,
the main burner will turn on immediately
.
3.
PAGE 52
Summary of Contents for Dassel DSL-36-RF
Page 68: ...PAGE 67...
Page 69: ...PAGE 68...
