QSEVEN-Q7AL - Rev.1.0
www.kontron.com
// 44
Sub-Screen
Function
Second level Sub-Screen / Description
Hardware Monitor>
(continued)
System Fan –
Fan Trip Point>
Displays temperature at which the fan accelerates.
(Range: 20°C – 80°C)
System Fan –
Trip Point Speed>
Displays Fan speed at trip point in %. Minimum value is 30 %.
Fan always runs at 100 % at (TJmax.-10°C).
CPLD
Configuration>
Serial Port 0>
Enables or disables the LVDS Flat Panel Display Support
[Enabled, Disabled]
Base Address>
Configure Serial Port Base Address
[3F8, 2F8, 3E8, 2E8]
IRQ>
Configure Serial Port IRQ
[7, 9, 10, 11, 12, 13, 15]
GPIO IRQ>
Configure IRQ for GPIO pins
[Disabled, 9, 10, 11, 12, 13, 15]
I2C IRQ>
Configure IRQ for I2C Controller
[Disabled, 9, 10, 11, 12, 13, 15]
Audio Codec Mux
Select>
Mux select for Audio Codec type on Carrier Board
[Mux to I2S Codec, Mux to HDA Codec]
GPIO-LPC Mux
Select>
MUX select for pin as GPIO or LPC Bus to pass through to carrier board
[Mux to LPC, Mux to GPIO]
GPO0 Mux
Select>
MUX select for the pin as GPIO or SUS_STAT
[Mux to GPIO, Mux to SUS_STAT#]
Carrier Settings>
Carrier
I2C0/SMBUS>
Switch to select which controller own the I2C_PM_CK & I2C_PM_DAT
pins on Qseven connector
[Use I2C0 Controller, Use SMBUS Controller]
Lid Switch Mode>
Shows or hides Lid switch inside ACPI OS
[Enabled, Disabled]
Sleep Button
Mode>
Shows or hides Sleep button inside ACPI OS
[Enabled, Disabled]
Watchdog>
Auto Reload>
Enables automatic reload of watchdog timers on timeout
[Enabled, Disabled]
Global Lock>
Enable sets all Watchdog registers (except for WD_KICK) to read only,
until the module is reset. [Enabled, Disabled]
Stage 1 Mode>
Selects action for Watchdog stage 1
[Disable, Reset, NIM, SCI, Delay, WDT Signal only]
Thermal>
Automatic
Thermal
Reporting>
Configure _CRT, _PSV and _AC0 automatically based on values
recommended in BWG’s Thermal Reporting
[Enabled, Disabled]
Critical Trip
Point>
Configure temperature value of the ACPI Critical Trip Point – point
which OS will shut the system off.
[15°C, 23°C, 31°C, 39°C, 47°C, 55°C, 63°C, 71°C, 79°C, 87°C, 95°C, 100°C,
103°C, 110°C, 119°C, 125°C]
Passive Trip
Point>
Configure temperature value of the ACPI Passive Trip Point – point
which OS will begin throttling the processor.
[Disable, 15°C, 23°C, 31°C, 39°C, 47°C, 55°C, 63°C, 71°C, 79°C, 87°C, 95°C,
103°C, 111°C]
Passive TC1
Value>
Sets the TC1 value for the ACPI Passive Cooling Formula. (Range: 1 – 6)
