Chapter 5
GTD-110/150
Basic Operation
5-18
0093151542-06
Table 5.2 Available picture modes
Picture mode
Descriptions
N up
True north is set at the top of the screen.
E up
True east is set at the top of the screen.
S up
True south is set at the top of the screen.
W up
True west is set at the top of the screen.
Course up
The waypoint position is set at the top of the screen.
Head up
Own ship’s heading is always set at the top of the screen. Own
ship is fixed in the center of the screen while the map moves
according to own ship’s movement.
Own ship center
fix
Picture is stabilized as North up, however, the map moves while
own ship stays in the center of the screen.
Operational notes:
1. When the cross cursor is shown, the cursor position is prioritized and the map movement is
suspended. When the cross cursor is turned off, the map starts to move according to the own
ship’s movement.
2. If the ship’s speed is less than 1 knot (1.8 km/h), Head Up mode is disabled to prevent erratic
map movement.
3. To operate GTD-110/150 in Head Up mode, you need to input the VTG sentence (in NMEA
0183) sent from an external navigation receiver. As long as the KODEN GPS sensor
KBG-2/KBG-3/GPS-10A is connected, you do not need to worry about this setting. The VTG
sentence is already set up. When you use a navigation receiver other than specified, please
check if they can provide TRUE bearing data in the VTG sentence. The GTD-110/150 cannot
accept MAGNETIC bearing. If the navigation receiver can supply both bearing data, refer to
the operation manual or contact the manufacturer for resetting.
5.10 Quick Info
The Quick Info shows information simply when the cursor is placed on points on the map (such as Ports,
Tide, Lighthouse, Buoys, Beacons, Obstructions, Landmarks etc.)
(1) Make "Quick Info" function effective by the MENU setting. Press MENU key.
(2) Move the highlight to "DISPLAY SETTING" using the joystick.
(3) Operate the joystick right. The submenu "DISPLAY SETTINGS" will be displayed.
(4) Move the highlight to ”SCREEN DISPLAY SETTING” using the joystick.
(5) Operate the joystick right. The submenu " SCREEN DISPLAY SETTING” will be displayed.
(6) Move the highlight to "QUICK INFO" using the joystick.
(7) Move the highlight to "ON" by operating the joystick to the right.
(8) End MENU by pushing the MENU key 3 times.
