Installing the RACKS
981088 – September 1995
45
Installing the DRYER RACK
Figure 38
Adjusting the Squareness of the
DRYER RACK
[1] Check that the tape holding the DRYER AIR
TUBES is removed. See Figure 2 on Page 6.
[2] Check that all DRYER AIR TUBES are seated
firmly in the SIDEPLATE.
[3] Manually turn the DRIVE PULLEY on the
DRYER RACK. Check that all ROLLERS turn
correctly. See Figure 39 on Page 45.
[4] Check the DRYER RACK for squareness by
placing it on a flat work surface with the TOP
COVER facing up.
If the DRYER RACK does not sit flat on the work
surface:
(a) Loosen the SCREWS for the COVERS and
the TIE RODS.
(b) Press down on the DRYER RACK until it
sits flat on the work surface.
(c) Tighten the SCREWS for the COVERS and
TIE RODS.
H130_0199AA
H130_0199ACA
Rack
Dryer