INSTALLATION INSTRUCTIONS
12
September 1995 – 981088
Installing the PROCESSOR on a Table Top
Warning
The unpacked, empty PROCESSOR weighs approximately 84 kg (185 lb). Use 2 people to move it. The PUMPS
are heavy and are located in the back of the PROCESSOR. Rotate the PROCESSOR so that each person supports
1
⁄
2
the weight of the PROCESSOR.
[1] Check that the work surface is capable of supporting a minimum of 113 kg (250 lb).
[2] Place the PROCESSOR on the work surface with the FRONT ACCESS PANEL facing the operator’s work
area.
(a) Check that all 4 LEVELING FEET are supported.
(b) Refer to the Site Specifications, Publication Number 981087, to check that you have room to access:
• the front of the PROCESSOR
• the ELECTRICAL BOX on the drive side of the PROCESSOR
[3] Locate the 4 FLOOR PLATES packed with the PROCESSOR.
[4] Insert the 4 FLOOR PLATES under the 4 LEVELING FEET of the PROCESSOR.
Figure 7
Installing the FLOOR PLATES
[5] Advance to the appropriate section as outlined below.
(a) If you are installing an M43A or Clinic 1 PROCESSOR for 60 Hz operation, advance to the section
“PROCESSOR Setup Options” on Page 35.
(b) If you are installing an M43A PROCESSOR for 50 Hz operation, advance to the section “Changing the
PROCESSOR to 50 or 60 Hz Operation” on Page 32.
H130_0147BA
PANEL
ACCESS
FRONT
LEVELING FOOT (4)
H130_0147BCA
FLOOR PLATE (4)
NUT (4)
