５
Mirror A
・
Adjust the mirror (A) so that the operator can identify the person who stands on the left rear ends
of machine (or post of 1.5m high and 30cm in diameter).
・
Install the mirror on the small diameter part (E) of the stay shown in the above figure.
・
Install the mirror so that the mirror (A) does not come in contact with the stay (1) of the mirror.
・
During adjustment, if the movement of the mirror (A) is not smooth, loosen nut (2) of the mirror
and adjust it.
Tightening torque of nut (2) M10: 18.6 to 25.5 N
･
m (13.7 to 18.8 lbf
･
ft)
・
Adjust mirror so that the machine side shown in the right figure is reflected in the mirror.
・
Regarding visible range, refer to previous page.
Mirror B
・
Adjust mirror so that person who stands on the right rear ends of machine (or post of 1.5m high
and 30cm in diameter) can be identified from operator.
・
Install mirror on position shown in the figure.
G : 400
㎜
{1'-4"}(Reference value)
・
Install it so that the mirror (B) does not come in contact with the stay (3) of the mirror.
・
If the movement of mirror (B) on adjusting is not smooth, loosen nut (4) of mirror and adjust it.
Tightening torque of nut (4) M8 : 8.6 to 12.7 N
･
m {6.3 to 9.4 lbf
･
ft}
・
Adjust mirror so that the machine side shown in the figure is reflected in mirror.
・
Regarding visible area, refer to the shaded range on 5.3.
［
5. TRANSPORTATION
］
5-13
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]
