1.
Using a hammer and punching tool,
hammer out the lock pin (4). Be careful not
to damage the rubber lock (3).
2.
Inspect the lock pin (4) and rubber lock (3).
Replace them if the lock pin (4) is too
short or the rubber lock (3) is in poor
condition.
3.
Clean the surface of the adapter nose (1)
with a putty knife to remove the adhered
soil.
4.
Fit the tooth point (2) onto the adapter
nose (1).
5.
Push the rubber lock pin (3) in the hole of
the adapter nose (1).
6.
Hammer the locking pin (4) until it is
aligned with the point surface.
E.1 Replacing the Tooth Points
Wear, goggles, safety shoes, hard hat, work clothes and work gloves to perform inspection and
maintenance on this machine.
Replace the bucket tooth in the following cases.
-When little holes appear on the tooth point.
-When the edge lines of the tooth point are worn.
［
4. MAINTENANCE
］
4-30
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]
