Kikusui TOS9200, Operation Manual

Page: 29 / 172

TOS9200/9201 Setup 1-7
1.5 Connecting the AC Power Cord
• This product is an IEC Safety Class I equipment (equipment with a protec-
tive conductor terminal). To prevent electric shock, be sure to ground
(earth) the unit.
• This product is grounded through the ground wire of the power cord. Be
sure to connect the power plug to an outlet with an appropriate earth
ground.
• Use the supplied power cord to connect to the AC line.
If the supplied power cord cannot be used due to the rated voltage or the plug
shape, have the cord replaced with an appropriate power cord of length 3 m or less
by a qualified engineer. If obtaining a power cord is difficult, consult your Kikusui
agent or distributor.
• The power cord with a plug may be used to disconnect the product from the AC
line in an emergency. Connect the plug to an easily accessible power outlet so that
the plug can be removed from the outlet at any time. Be sure to allow enough
space around the power outlet.
• Do not use the supplied power cord on other instruments.
This product is an equipment of IEC Overvoltage Category II (energy-consuming
equipment supplied from the fi xed installation).
1. Turn the POWER switch off.
2. Check that the AC power line complies with the input rating of the
tester.
See "1.4 Checking the Line voltage and Fuse".
3. Connect the power cord to the AC LINE connector on the rear panel,
connect the power cord plug to an outlet with proper grounding.
Fig.1-5 Plug connection
WARNING
NOTE
Grounded three-contact
electrical outlet