Keysight 41800A, Operation Note

Page: 56 / 61

58 Keysight 41800A Active Probe
Service
Disassembly
6-
PC Board/Heatsink Assembly Disassembly
1. Remove the cable strain relief BOOT using the following procedure.
a. Hold the probe by hand at position A as shown in Figure 6-3 .
b. Remove the BOOT by rotating it in the direction of arrow B as shown in
Figure 6-3 .
c. Slide the BOOT in the direction of arrow C as shown in Figure 6-3 .
Figure 6-3 Boot Removal
2. Slide the SLEEVE in the direction of arrow A as shown in Figure 6-4 .
Figure 6-4 Sleeve Removal
3. Pull out the CE RING in the direction of arrow A as shown in Figure 6-5 .
Figure 6-5 CE Ring Removal
4. Remove the probe NOSE piece using the following procedure.
a. Use a wrench to hold the NOSE piece at position A as shown in Figure
6-6 .
b. Remove the NOSE piece by rotating it in the direction of arrow B as
shown in Figure 6-6 .
c. Remove the NOSE piece.