18
Keysight 41800A Active Probe
Operation
Overview
3-
Probe Tip Nut
Driver
This is used to replace the probe pin. Refer to
“Probe Pin Replacement” on page 32
.
10229A Hook Tip
Adapter
This is used to hook on to the test point of the device under test.
Probe Pins
Two kinds of probe pins, 12 mil pin and 30 mil pin, are available for the 41800A. Three 12
mil pins and three 30 mil pins are furnished with the 41800A as spare probe pin set. The
41800A is shipped from the factory with a 30 mil pin installed.
The 30 mil probe pin must be used, when using with the Keysight probe-BNC(m)
adapter, the 10:1 / 100:1 dividers, the slip-on spanner ground tip, the hook tip adapter.
To replace the probe pin, refer to
“Probe Pin Replacement” on page 32
.
