Keysight Technologies U3810A, Getting Started Manual

Page: 120 / 134

Keysight U3810 Series Getting Started Guide 120
Appendix G – Restore U3810A startup files
1 If you are continuing this lab from previous lab session;
a
Make sure your U3810A jumper settings are set up according to Set Up the U3810A System .
b Connect your PC to the BeagleBone with a USB cable. Refer to Set Up Secure Shell (SSH)
Communication .
c
Establish a secure shell communication with the BeagleBone. Refer to Set Up SSH
connection .
2
Run the following command to unzip the Startup Scripts from its ZIP archive.
cd ~/LabCode
tar -xzf startup_scripts.gz
3 Execute the following command to change your working directory to the startup directory.
cd startup_scripts
4 Execute the following command to run the autodisplay.sh script. This will reset your U3810A
startup to the factory state.
sudo ./autodisplay.sh